Our proven thermal film BSF (iron-on embroidery film) "FusyFilm" Thermal Foil to make patches ironable on textiles Mounting with electric iron or hot press to the back of embroidered badges. The durability according to the manufacturer is up to 60 degrees. Price per running metre, width: 49cm. Processing instructions: 1. Embroider patches, preferably on SUMa or SUMa-Soft embroidery backing. 2. 2. remove the patch from the embroidery hoop and turn it inside out. 3. preheat the iron or transfer press. Press the thermal foil with the protective paper facing upwards (so that it does not stick to the heating plate) at approx. 130 - 150 degrees Celsius for three to five seconds. 4. peel off the protective paper. 5. Apply a second layer of thermal foil (see point 3); the first layer is absorbed well by the embroidery base, the second layer then adheres very well to the textile. 6. peel off the protective paper. 7. cut out the patch with scissors. 8. iron the patch onto the desired area from the front for approx. 3 seconds using an iron or transfer press. 9. turn the textile onto the reverse side and press from the back for approx. 15 - 20 seconds at approx. 130 - 150 degrees Celsius (ATTENTION: The contact pressure must not be too high, otherwise the patch will become saturated with the adhesive layer and will not adhere to the textile). This causes the adhesive to melt into the fabric and adhere perfectly. Roll 100 m x 49 cm. Apply with an iron or hot press to the back of embroidered patches. Durable up to 60 degrees according to manufacturer's instructions, wash-resistant. Note: The above information is for guidance only. The final result will vary depending on the fabric and working conditions. Preliminary tests on loose fabric recommended.
Oak leaf to iron on Price per set with one piece for the left side and one piece for the right side colors: gold or silver Instructions: 1. Place the oak leaves as desired on the textile or cap 2. Overlay it with a linen cloth 3. press the iron or ironing press on the desired position for about 3 seconds at level 3 4. Allow to cool